Question 1

How do I properly use the tool setter? My tool is either plunging into the workpiece or air carving.

Accepted Answer

There is a particular order you must conduct your setup in. Click the link below to see the guide "Using the Toolsetter with Redline Controller"
https://forum.onefinitycnc.com/t/using-the-toolsetter-with-redline-controller-quickstart-guide/37933/1

Question 2

How do I ground my machine to prevent static EMI (Electro Magnetic Interference)?

Accepted Answer

See Forum Blog post:
 Redline Controller Grounding FAQ - Machines (Elite w/ Redline) / Official 1F Elite (REDLINE) FAQs category - Onefinity CNC Forum

Question 3

What fuse is used with the Redline HMI Screen?

Accepted Answer

T6AL250V 5x20mm 6A 250V Slow Blow Fuse T6AL Glass Slow-Acting Time-Delay Fuse (3/16 in x 3/4 in)

See Forum blog here:
Redline Screen HMI Fuse Spec (FAQ) - Machines (Elite w/ Redline) / Official 1F Elite (REDLINE) FAQs category - Onefinity CNC Forum

Question 4

"No COM ports detected" Displayed when I power up my Redline CNC Control System.

Accepted Answer

Ensure the included and required USB cable between the HMI (Touch Screen) and RealTime CNC Motion Controller Box (Black Box all motors and sensors are plugged into) is properly plugged in.

See Forum Blog post:
Redline USB Cable Connection (no com detected, work offline, alarm state) (FAQ) - Machines (Elite w/ Redline) / Official 1F Elite (REDLINE) FAQs category - Onefinity CNC Forum

Question 5

How do I mount my Jtech Laser SI Board?

Accepted Answer

The SI board can be mounted on the back of the Redline HMI (Touch Screen).

See Forum Blog post:
JTech Laser SI Board Mount STL - Machines (Elite w/ Redline) / Official 1F Elite (REDLINE) FAQs category - Onefinity CNC Forum

Question 6

What are the computer system requirements for the Redline Control System without HMI?

Accepted Answer

https://realtimecnc.com/product_specs/#system-requirements